In the application of ozone generators, especially in the application of water treatment, in the process of mixing ozone and water, there will always be ozone molecules and water can not be completely mixed, but these ozone molecules will be concentrated in the transmission position above the water surface, if the direct discharge will cause oxidation of nearby vegetation, direct discharge into the room is not allowed in the case of people.
After continuous research by technicians, they came up with a way to decompose these excess gases directly into oxygen, which led to the later ozone destroyer, ozone decomposer to crack these excess ozone molecules, and then reduce them to oxygen and carbon dioxide.

Principle of ozone destruction: Ozone exhaust gas destroyer for heating – catalyst mixed type. When the ozone tail gas enters the reaction chamber, the ozone molecules are decomposed through the catalyst, and then the tail gas is discharged from the catalytic bed by the centrifugal fan. A heating device is arranged at the entrance of the breaker to preheat the tail gas to prevent condensation in the catalyst and affect the decomposition effect of the catalyst. The heating temperature can be generated by the electric heating ratio, and it will be necessary to connect the catheter to the ozone cracker, and then the cracker will be powered on to complete the treatment of ozone.
There is another method: activated carbon absorption carbon, this is not recommended.
Selection of ozone annihilator: according to the proportion of ozone input gas to choose, depending on the mixing rate. If you can make a decision in the selection, be sure to consult the supplier to complete the selection